SET-UP AND INITIAL USE
Insert and replacing the battery
The package includes a CR2 battery. Remove the
battery from the packaging. Flip up one half of the
battery cover. With this lever you turn the battery
compartment counterclockwise to open the battery
compartment. Insert the CR2 3-Volt lithium battery
with the negative contact facing into the battery
compartment. Close the battery compartment with
the battery cover, turning clockwise. Hand-tighten
the battery cover and fold the clip back to its starting
position. Be careful not to over tighten because the
battery cap can break the fl ip lever. If the battery cap
is not installed properly the battery compartment may
not seal properly.
Please check the battery every 3 months to prevent
battery leakage.
Most CR-2 batteries will run for several years in your
rangefi nder; however we recommend replacing the
battery every year. Please always dispose of the bat-
tery in designated containers or dispensing stations
(see details in chapter „Disposal of electrical and
electronic equipment").