Table Des Matières - joke EUR Mode D'emploi Et Entretien

CONTENTS
1. GENERAL NOTES ......................................................
2. DESCRIPTION OF THE UNIT AND ASSEMBLY ..............
3. TECHNICAL SPECIFICATIONS ....................................
4. IMPORTANT WARNINGS ............................................
5. INSTRUCTIONS FOR USE ...........................................
6. MAINTENANCE ..........................................................
7. WASTE DISPOSAL ....................................................
1. GENERAL NOTES
Please read this booklet carefully. It contains important information about safe installation, use and maintenance. Keep this booklet in a convenient place for further reference.
1.1 Check the general condition of the unit after removing the packaging. When in doubt do not operate the unit and contact a qualified service repair person authorised by
SIMED.
1.2 Before connection, check to see that the identification plate indicates the correct voltage for the electrical supply system. lnstallation must be carried out in compliance with
all applicable safety standards and in accordance with the manufacturer's instructions. The manufacturer will not be held responsible for demage to objects and/or harm to
people caused by improper installation. The unit is safe only when connected correctly to ground via an appropriate device in accordance with safety standards. This
fundamental requirement must be satisfied. If in doubt, request a thorough inspection of the system by a professionally qualified technician. The manufacturer will not be held
responsible for damage caused by an improperly grounded system.
1.3 This unit should only be used as intended by the manufacturer. Any other use must be considered inappropriate and consequently dangerous. The manufacturer will not be
held responsible for damage caused by improper, erroneous or unreasonable use.
1.4 Switch-off and unplug the unit from the etectrical outlets before servicing.
1.5 Carefully follow cleaning instructions as in the manufacturer's manual.
1.6 In cases of breakdown or unit malfunction, turn the unit off and do not try to repair it. Contact only qualified and authorised SIMED agents. Any subsequent repairs made to
the unit must be carried out by the manufacturer or by an authorised agent using original SIMED replacement parts only. Not following the above procedure could jeopardise
the safety on the unit. Connection to the electrical distribution system must be made by using only plugs that conform to safety standards.
1.7 Check that the electrical supply system is adequate for the maximum power consumption/rating as indicated on the identification piate. When in doubt, contact a
professionally qualified technician. The technician must check that the system cables are adequate for the current drawn by the equipment. The use of adapters, multiple plugs
and extension cords is not advisable. If absolutely necessary, use devices that conform to safety standards, being careful not to exceed the limit values indicated on the device
itself.
Rev. 2 24/06/2005
Suction unit EUR
8
9
9
9
10
11
11
7 / 19