Spector&Co SPECTECH ADDI VINYL Mode D'emploi page 2

Accessories included: Micro or Mini USB charging cable & 3.5 mm AUX cable
Product Size: 60mm x 60mm x 50mm
Net Weight: 230g
To charge the Addi Vinyl
1. Insert the mini USB tip of the charging cable into the Addi Vinyl & connect USB output to
a wall adapter (not included)
2. Red Led light indicates the speaker is in charging mode. Red Led will turn off when
speaker is fully charged. (charge time is approximately 2 hours)
Operation
Bluetooth Mode
1. Pairing the Addi Vinyl with your audio device
a. Push the Addi Vinyl on switch to the LEFT to activate the Bluetooth function (LED light
will flash blue/red to indicate the speaker is ready for pairing)
b. Turn on the Bluetooth on your audio device
c. Device name is Spector Addi (no pairing password required)
d. Blue LED light will flash once connected
** To re-activate a Bluetooth connection with a previously paired Bluetooth device, press the
button immediately when the speaker is turned on (switch button to the LEFT). Bluetooth
connection will resume.
NOTE: To disconnect Bluetooth, press & hold the
2. Operation in Bluetooth mode
a.
Quick Press: Play next song
Long Press: Volume increase
b.
Quick Press: Play last song
Long Press: Volume decrease
c.
Music mode: Quick Press to Play/Pause
Call mode: Quick press to Answer/End a call/ Long press (hold for 2 seconds) to reject
incoming call/ Double-quick press to redial last number
NOTE:
After a call is terminated, the Addi Vinyl will resume to previous working status.
Red LED light will flash to indicate low battery
AUX in Mode
1. Push the Addi Vinyl on switch to the RIGHT to activate AUX mode (green LED light will
remain lit in AUX mode)
2. Connect the AUX cable to the speaker & to your audio device
3. When in AUX mode you must use your audio device to operate the speaker (play/pause
skip songs/volume control & answer/end phone calls)
button