SEVERIN 77743 Mode D'emploi page 6

Dear Customer,
Before using the appliance, the user should
read the following instructions carefully.
Familiarisation
1. Display selection key
2. Weighing platform / glass plate
3. Plastic housing
4. On/zero-reset-key
5. Digital display
6. Battery compartment
7. Rating label
Important hints
●
If repairs are needed, please send the
appliance to one of our customer service
departments. The address can be found
in the appendix to this manual.
●
Do not clean the scales with water and
do not immerse them in water.
●
The display can be changed between
grams (gm) and ounces (oz) by using the
appropriate key (1).
●
These scales have a maximum load
capacity of 5000g / 176.37 oz (accessories
included). If this capacity is exceeded, the
symbol 'EEEE' appears in the display.
●
These scales are designed for household
use and are not suitable for medical or
commercial applications; they are not
officially calibrated.
Before using for the first time
Before the scales are used for the first time,
the protective strip in the battery
compartment must be removed.
Fit the the glass plate onto the centre axis
with the centre bolt. To secure the plate, use
a suitable screwdriver to tighten the small
grub-screw on the side of the bolt.
Operation
- Position the scales on a firm and level
surface.
All manuals and user guides at all-guides.com
Kitchen scales
- To weigh recipe ingredients, place a
suitable bowl or container on the
platform. Solid ingredients may be put
directly onto the scales.
- To switch the unit on, press the 'On' key.
The '0' symbol appears in the display. To
allow for any additional weight, always
make sure to position any accessories
(bowl etc.) on the platform before the
unit is switched on.
- Add the ingredients to the bowl (or other
accessory) used, until the desired weight
is displayed.
- To add more ingredients without first
emptying the container, the zero-reset
key may be pressed again. In this way,
only the additional weight is displayed.
- After use, the scales may be switched off
by holding down the On/zero-reset key.
However, the unit will switch off
automatically if no key is pressed within a
90-second period.
Batterie
- The symbol
needs replacing.
- To insert or replace the battery, open the
battery compartment located underneath
the unit. When inserting the battery,
always observe the correct polarity. The
symbol (+) must face upwards.
- Use one 3 V lithium battery type CR
2032.
- During extended periods of non-use,
always remove the battery from the
battery compartment.
- Remember to protect the environment.
Never dispose of old batteries in
domestic garbage. Old batteries must be
disposed of through the proper local
special garbage collection points.
Cleaning and care
●
The housing and glass plate may be
wiped with a soft dry or slightly damp,
lint-free cloth. Special, commercially
available cleaning agents for glass may
also be used for cleaning the glass plate.
3
appears if the battery