LBX instruments V10 Mode D'emploi page 2

V10 series Vacuum pump with valve and vacuum gauge,
Important notice
This instrument is designed for laboratory usage only. Please read this manual carefully before installing or operating this
equipment. The instrument shall not be modified in any way. Any modification will void the warranty and may result in
potential hazard. We are not responsible for any injury or damage caused by any non-intended purposes and modifying
the instrument without authorization.
1. Check the voltage specified on the name-plate and ensure it matches the line voltage in your location.
2. The pump is not corrosion-proof. Please do not operate it with corrosive gases directly.
3. Install the instrument in a clean, dust-less and ventilated area under 40℃.
4. The Prote filter cartridge can prevent a large amount of liquid from overflowing into the pump. Please ensure the
TM
liquid level of flask not exceed safety level. Failure to comply can result in serious damage to the pump and void the
warranty. If it occurs, please contact the distributor immediately for service.
5. The filter cartridge is used to absorb moisture and dust. Please replace the cartridge to maintain proper pumping
efficiency when it is saturated.
6. To avoid damaging the pump easily, please vent the pump before starting the pump.
7. Don't incline the pump during work to prevent the Prote
8. This pump has a thermal protection device that automatically shuts-off when it becomes overheated.
9. The temperature of the surface of pump is very high after use or during work, please don't touch it to avoid being
burnt.
10. Do not use any lubricant, which may damage the pump.
11. Never spray flammable or toxic materials.
If the supply cord is damaged, Please contact the manufacturer or your service agent for replacement to avoid hazard.
User Manual
20 l/min, 105 mbar
filter cartridge from blocking the air inlet.
TM
2