Spector&Co SPECTECH T317 Mode D'emploi page 2

T317 Product Map
Earbuds in magnetized state
1. T317 Operation
a) On: press & hold the
seconds to indicate the T317 is ON). Earbuds is now in STANDBY mode
b) Off: press & hold the
NOTE: previously paired devices will automatically connect to the T317 earbuds when turned on. T317 will power
off automatically after 10 minutes if not used in standby mode
2. T317 Wireless Pairing
a) Pairing: Make sure T317 is OFF. Press & hold
(blue/red flashing LED indicates the device is ready for pairing)
NOTE: the earbuds must be separated from magnetized state to successful pair with your audio device
b) Refresh connectivity: Press & hold
c) Enable Bluetooth function on your electronic device. Search Spector T317 & pair the devices (blue LED
will flash once every 10 seconds when paired)
Microphone
Table of Content for Multi-Function button
Description
Power On/Off
Ready for pairing
Play/Pause
Disconnect wireless mode
Answer/End incoming calls
Reject incoming calls
Redial last caller
Voice dialing
button for 4 seconds until the LED flashes BLUE twice (LED will flash blue every 5
for 4 seconds until the LED light flashes RED
for 1 second until LED light flashes blue
Skip songs/volume up
Multi-function button
Previous song/volume up
Micro-USB input port
Section
Refer to 1a & 1b
Refer to 2a
Refer to 3a
Refer to 2 in NOTE
Refer to 3a
Refer to 3b
Refer to 3c
Refer to 4a
button for 7 seconds until LED light flashes blue & red