Parts; Warning - Baby Trend HC38 A Serie Manuel D'instructions

WARNING

WARNING:
the instructions could result in serious injury or death.
FALL HAZARD:
head injuries including skull fractures when falling from
high chairs. Falls can happen suddenly if child is not
restrained properly.
• ALWAYS use restraints, and adjust to fit snugly.
• Tray is not designed to hold child in chair.
• Stay NEAR and watch child during use.
• NEVER allow child to push away from table.
STRANGULATION HAZARD:
Do not place High Chair in any location in any location
where there are cords, such as a window blind cords,
drapes, phone cords etc.
WARNING:
the high chair at all times by the 5-point restraining
system, either in the reclining, semi-reclining or upright
position. The tray is not designed to hold the child
in the chair. It is recommended that the high chair be
used in the upright position only by children capable of
sitting upright unassisted. See page 9 for instructions
on proper use of restraint system.
• approved SNAP TECH products can be used on the frame.
ONLY
TM
• Other accessory items may change the balance of the high chair and cause hazardous
unstable conditions, use approved Baby Trend toys only.
• Be certain the high chair is fully erect and latched in the open position before allowing the
child near the high chair.
• Use of the high chair with a child weighing more than 40 pounds will cause excessive wear
and stress on high chair.
• allow your high chair to be used as a toy.
NEVER
• use this product if there are any loose or missing fasteners, loose joints, broken
NEVER
parts, or torn mesh/fabric. Check before assembly and periodically during use. Contact
Baby Trend Customer Service at 1-800-328-7363 for replacement parts, repair or
instructions. substitute parts.
NEVER
3
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Failure to follow these warnings and
Children have suffered severe
The child should be secured in
IMPORTANT!
To ensure safe operation of your product, please follow
these instructions carefully. Please keep these instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. NEVER use if
any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked in the open
position before using.
ATTENTION:
Carefully remove parts from box. Check that you have all the parts for this model before assembling the
high chair. NOTE: Certain High Chair models are packaged with the High Chair Seat Fabric and Body
Insert already attached to the Seat Back.
WARNING:
Do not sit
on the frame when the seat is
not attached. Do not use frame
as a foot stool. Potential pinch
point when opening the frame.
TO ASSEMBLE FRAME
• Take the left and right Upper Frame
1)
Assemblies, push the legs apart until fully
open and locked. Push downward on fold
levers (left and right) to ensure frame is
locked open (Fig. 1a).
• Insert the front tube of the right and left
side Upper Frame Assemblies into the
Height Adjuster (Fig. 1b). The front tube is
easily distinguished from the rear tube by
the array of holes located on the backside
of the front tube.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
DO NOT place Push down
to lock open
fingers here.
Fig. 1a
Fig. 1b
4