IRIS MH4LED Instructions D'installation page 3

5. Using top access (Figure 5.), install LED module onto
the collar using the hook legs first, then pivoting the
module body to allow the spring clips to snap into the
aligned cutouts (Figure 6.).
If installing module from below the ceiling/through the
aperture, rotate spring clips on the LED module to be flat
(Figure 7 .). Feed the module through the aperture, spring
clip side first (Figure 4.). Mount the hook legs onto the collar
first (Figure 6.). Rotate spring clips into vertical position,
allowing for engagement with collar cutouts (Figure 8.).
6. In order to securely mount the module to the housing,
install the two mounting screws into the spring clip
slots (Figure 9.).
Figure 6.
Figure 7.
Installation Instructions – Module MH4LED
Dimminge: Dimming is only available on 120 VAC
installations. 277 VAC installation is only available on select
driver options. Consult product specification sheets for
dimming and electrical information. Consult your local
IRiS representative for further information on dimming,
installation or compatibility.
Special Instructions and Applications
Lamping Notee: IC and Non-IC platform lamp wattage
ratings may be different. Use only lamps listed on the
element label specific to the platform installed.
Elementse: Installation of element into housing platform
is performed after the housing platform is installed in the
ceiling, the module is installed in housing platform and the
aperture opening has been cut into the ceiling. Refer to the
Installation Instruction sheet for the element being used for
proper installation and lamping instructions.
Figure 8.
Figure 9.
COOPER LIGHTING SOLUTIONS IB520005EN Installation instructions
3