How To Use - IRIS USA IRIS WOOZOO PCF-SDC15T Serie Mode D'emploi

hOW TO USE

Place the Product
Place the product upright on a stable surface and insert the charger plug
into the product, then insert the adapter plug into the electrical outlet . The
product will beep when buttons are pressed .
Start the Product
Press the power button to turn the product on .
• The product will start running at the last setting used if the power
plug has not been pulled out .
• The product can also be turned on using the power button on the
remote control .
Select the Operating mode
Pressing the Mode button changes the product mode as follows:
Continuous Breeze
Full oscillation
Continuous
Product runs with a continuous air flow at the chosen air flow
strength .
Natural Breeze Pattern
Replicates breeze patterns by changing the strength of the air
flow .
Focused Oscillation
When operating in focused oscillation mode, product will operate
on high, oscillating up to 60 degrees then down to 45 degrees .
After settling at 45 degrees, the product will begin left and right
oscillation within a 30 degree angle .
While oscillating up and down, the vertical oscillation indicator
light will also be illuminated . While oscillating left and right, the
horizontal oscillation indicator lights will also be illuminated .
When operating in focused oscillation mode, the horizontal
oscillation, vertical oscillation, and air flow strength cannot be
adjusted .
Product modes can also be selected by pressing the desired mode setting
button on the remote .
7
Select the Preferred Air Flow Strength
Pressing the air flow strength button lights the indicator light and changes
the air flow strength .
Continuous mode offers 10 strength settings . The natural breeze pattern
mode offers 3 strength settings .
In continuous mode, holding the button will cause the air flow strength to keep
changing until the button is released .
• Press the left arrow button to decrease air flow .
• Press the right arrow button to increase air flow .
Set Delayed Start Time
The delayed start timer can only be set while the product is off but plugged in,
or after the timer has been set . It cannot be set while the product is running
unless the desired run time has already been chosen .
Pressing the delayed start button changes the delayed start time as follows:
2 (h) 4 8
Delayed start off
The delayed start time can also be changed using the delayed start button on
the remote control .
While the delayed start timer is running, the indicator light will change
according to time remaining . When time runs out, the product will start
operating .
Start Timer
Pressing timer button changes the preset time as follows:
2 (h) 4 8
Timer off
The timer can also be changed using the timer button on the remote control .
While the timer is running, the indicator light will change according to time
remaining . When time runs out, the product will turn off and stop running .
If the product is oscillating when the desired run time runs out, the product
will not reset to the front position .
8