Baby Trend DJ99 Manuel D'instructions page 4

ASSEMBLY
IMPORTANT!
To ensure safe operation of your stroller,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
Remove stroller from box. The front
wheel, rear wheels, fender, and parent
tray need to be installed prior to use.
FRONT WHEEL
WARNING:
wheel utilizes a front wheel
double nut locking system.
Please follow all of these
instructions to ensure the
safety of your child. Failure
to follow these instructions
could result in serious
injury or death.
To attach the front wheel, unfold stroller
as described in the section following:
1) • Lean the stroller backwards so that it
rests on the handle and rear axle frame
and the front wheel forks are pointing
upward (Fig 1).
2) • Slide the front wheel onto the front forks
(Fig. 2).
5
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
This
Fig. 1
Fig. 2
3) • Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
4) • With the wheel in position, install the axel
nuts and tighten with standard crescent,
box, or open end wrench. You should
feel significant resistance and the wheel
should be held tightly in place (Fig. 4).
FENDER
To secure the fender to the frame, use the 5
screws provided.
5) • Examine the bottom of the front fender.
You will notice four 1/4 inch diameter
plastic tubes protruding from the bottom.
(Fig. 5a).
• These tubes must be lined up with the
holes in the front frame assembly
(Fig. 5b).
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Front Fork
Slot
Axel and Hub
Axel Nut Retainer Plate
Fig. 3
Fig. 4
Fig. 5a
Fig. 5b
6