OPERATION
• Wrap the back straps around the back
of the chair. Buckle the straps making
sure you hear the buckle *CLICK* closed
(Fig. 21c).
• Pull the free ends of the strap to firmly
tighten the Booster Seat to the chair
(Fig. 21d).
• Wrap bottom straps around the bottom
of the chair. Buckle the straps making
sure you hear buckle *CLICK* closed
(Fig. 21e).
• Pull the free ends of the straps to firmly
tighten the Booster Seat onto the chair
(Fig. 21d).
• Check that the Booster is tightly installed
by attempting to move the Booster Seat
from side-to-side and up. The Booster
Seat should not move more than 1 inch.
TO REMOVE BOOSTER SEAT
FROM CHAIR
22)
• Turn Booster Seat over. Slide Strap
Compartments open on the bottom of
the Booster Seat (Fig. 22a).
• Fold the straps and put them in
the compartment, then slide the
Compartment Door closed (Fig. 22b).
15
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT
Fig. 21c
•
ONLY
used on the frame.
ADJUST FRAME HEIGHT
Fig. 21d
Fig. 21e
Fig. 22a
23)
ATTENTION:
The Height Adjustment Bracket must be set at the
lowest postion before placing car seat (Fig. 23b).
Fig. 22b
WARNING:
Avoid
serious injury from falling or
sliding out, always use the
Infant Car Seat harness.
approved
SNAP TECH
products can be
TM
WARNING:
Do not adjust
car seat height with child in seat.
Adjust seat height before placing
your child in the car seat.
WARNING:
Always
check that the Height Adjustment
Bracket is level and both left and
right sides locked before placing
child in the car seat.
WARNING:
Never use
the car seat mode at any of the
higher positions. Always use the
car seat at the lowest position.
WARNING:
Never rest
the height adjustment bracket
on the locking pins.
• Squeeze both left and right Release
Handles of the Height Adjustment Bracket
and adjust to the lowest position (Fig. 23a).
DO NOT adjust with child in the seat.
Copyright © 2019, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
OPERATION
Release Handle
Fig. 23a
Highest Position
Lowest Position
Locking Pin
Fig. 23b
16