Infant Car Seat - Baby Trend Navigator Lite Double Jogger Manuel D'instructions

SAFETY
TO RELEASE THE CHILD
Type 1
• To release, push Button on Center Clasp,
14)
the two Harness Buckles will pop
free (Fig. 14).
Type 2
• To release, apply pressure to both sides
15)
of each male clip until the clip is released
(Fig. 15).
JOGGING WITH YOUR STROLLER
WARNING:
Never jog or run with
your newborn in the car seat position.
Use for strolling only.
STRANGULATION
HAZARD!
Children have strangled
when straps have wrapped around their
neck. When not in use hook the tether
strap onto the stroller handle. Keep this
stroller tether strap out of the reach of
children.
• When you are jogging with your child,
use the following safety features:
• LOCK THE FRONT SWIVEL WHEEL IN STRAIGHT
16)
POSITION (Step 12)
• SAFETY WRIST STRAP: Always connect the safety
strap to either wrist when jogging. This strap will
keep the stroller from rolling away in the event that
you trip while running (Fig. 16a). The safety strap
must remain connected to the rear lower frame
cross member at all times. This location is intended
to prevent the stroller being tipped backward in the
event that you do fall to the ground. The safety strap
includes a hook and loop attachment for storage, on
the left side of the stroller, when not in use (Fig. 16b).
11
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
INFANT CAR SEAT ATTACHMENT
Type 1
Center Clasp
Fig. 14
Type 2
17)
Fig. 15
Fig. 16a
TO REMOVE INFANT CAR SEAT
18)
Fig. 16b
WARNING:
Never jog
or run with your newborn in
the car seat position. Use for
strolling only.
WARNING:
Avoid
serious injury from falling
or sliding out, always use
the Infant Car Seat harness.
• Position the infant car seat so that it
faces toward the rear of the stroller and
the car seat base hooks lock onto the
bumper bar (Fig. 17a).
NOTE: Check that the bumber bar is
firmly attached to the stroller.
• Adjust the seat back to its most upright
position (Fig. 17b) .
• Strap both short clips over the infant car
seat, through both seat belt slots
(Fig. 17c).
NOTE: Make sure both short clips are
tightly fastened to the infant car seat
before use.
• To remove the Infant Car Seat, unstrap
the short clips from each belt slot and
squeeze the release handle located at
the foot-end of the seat and carefully lift
upward on the seat (Fig. 18).
NOTE: Raise the support tabs when the
car seat is not in use.
Copyright © 2017, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

INFANT CAR SEAT

Fig. 17a
Fig. 17b
Short clips
Fig. 17c
Fig. 18
12
12