Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1. Remove the faceplate from the base by unscrewing the screw underneath
the thermostat and tilting the bottom of the faceplate up. Note that the
screw remains captive on the base.
2. Insert the wires through the center hole of the base and secure the base to
the wall or onto an electrical box.
3. Connect the wires to the terminals (no polarity to observe).
Terminal
1 TH
AQ2000 Series hydronic zoning controller connections
2 TH
3 SENSOR External sensor connections for floor temperature measurement
(required only if the thermostat is set to F or AF mode; see page 4
4 SENSOR
and 11)
4. Set the configuration switches (see next page).
5. Re-attach the faceplate to the base and secure with the captive screw.
NOTE: Keep the thermostat's air vents clean and unobstructed at all times.
Description
10
69-2005EF—02
Publicité
Chapitres
Table des Matières
