AMIX AFF20-60mn Manuel Utilisateur page 16

Next
SOFTWARE
SOFTWARE
1 Offset adjust (from +32 dB to -32dB).
2 Alarm level setting (using + or – keys or slider)
3 Access to the code modification. From factory the code is
4 Diagnostic button: shows the configuration in use in the window. When the equipment shows
an error, this button allows an easy diagnostic of the occurred problem.
5 Reset button, returns to default configuration.
6 Setting of the central display: choose Leq 1s, 5mn, 10mn or 60mn.
7 Setting of the lower left display: choose Leq 1s, 5mn, 10mn, 60 mn or disabled.
8 Setting of lower right display: choose peak level or disabled.
9 Choose luminosity, automatic or manual.
10 Choose luminosity type indoor or outdoor only in automatic mode.
11 Luminosity setting in manual mode only.
12 Serial number display (no change allowed).
13 Transfer progress display bar.
14 Date modification according to the selected date in the contiguous window
15 Time modification according to the selected date in the contiguous window
16 Key to activate automatic date change (default enable).
17 Allow to choose the connection: connection to a sensor (Cap20) or connection to a level
controller
18 Dialog bow with AFF series equipments.
Note: - Even the pass word is unknown, it is possible to display the parameters , to save
and print them. It is only necessary to select "Visualisation des parameters" in
"Paramètre" menu.
It is impossible to display at the same time the Leq5 and the leq10.
AMIX - AFF20-60mn
1052 .
15
ENGLISH