Korg MetroGnome MM-2 Manuel Du Propriétaire

4015-2 Yanokuchi, Inagi-city, Tokyo 206-0812 Japan
© 2003 KORG INC.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Complies with Canadian ICES-003 Class B.
Conforme au Reglement Canadian NMB-003 classe B.
Thank you for purchasing the MetroGnome MM-2.
Precautions
Location
Using the unit in the following locations can result in a malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
• Close to magnetic fields
Power supply
Be sure to turn the power switch to OFF when the unit is not in use. Remove the battery in order to prevent it from
leaking when the unit is not in use for extended periods.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference. Operate this unit at a suitable distance
from radios and televisions.
Handling
To avoid breakage, do not apply excessive force to the switches or controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid cleaners such as benzene or thinner, or
cleaning compounds or flammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets into the equipment, it could cause a
breakdown, fire, or electrical shock. Be careful not to let metal objects get into the equipment.
THE FCC REGULATION WARNING (for U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instr uctions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Unauthorized changes or modification to this system can void the user's authority to operate this equipment.
CE mark for European Harmonized Standards
CE mark which is attached to our company's products of AC mains operated apparatus until December 31, 1996 means it
conforms to EMC Directive (89/336/EEC) and CE mark Directive (93/68/EEC).
And, CE mark which is attached after January 1, 1997 means it conforms to EMC Directive (89/336/EEC), CE mark
Directive (93/68/EEC) and Low Voltage Directive (73/23/EEC).
Also, CE mark which is attached to our company's products of Battery operated apparatus means it conforms to EMC
Directive (89/336/EEC) and CE mark Directive (93/68/EEC).
IMPORTANT NOTICE TO CONSUMERS
This product has been manufactured according to strict specifications and voltage requirements that are applicable in the
country in which it is intended that this product should be used. If you have purchased this product via the internet, through mail
order, and/or via a telephone sale, you must verify that this product is intended to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for which it is intended could be dangerous and could
invalidate the manufacturer's or distributor's warranty.
Please also retain your receipt as proof of purchase otherwise your product may be disqualified from the manufacturer's or
distributor's warranty.
INSTALLING THE BATTERY
1. Turn the cap toward the left and remove it.
2. Insert the battery with the positive (+) side up.
3. Press the battery into place, and use the tab to hold it in position.
1 2
To avoid damaging the unit, don't use excessive force when inserting the
battery.
4. Replace the cap.
If nothing appears in the display, the battery may need replacing.
When you replace the battery, you must remove the old battery and then hold
down the Mode button for a few seconds before installing the new battery.
REMOVING THE BATTERY
1. Turn the cap toward the left and remove it.
2. Hold the MM-2 with both hands as shown in the diagram.
3. Use your thumb to push up the tab that holds the battery in position and
remove the battery.
2
To avoid damaging the unit, don't use excessive force when pushing the tab.
PLACING THE MM-2 ON YOUR EAR
1. Hold the MM-2 with the display facing your palm and raise the ear hook.
2. Place the ear hook around your ear.
The most stable position will depend on the shape and size of your ear. Adjust
the angle to find the position that is most comfortable for you.
3. Make sure that your earlobe is within the ear hook and gently fold the MM-2
back against your ear.
2
ABOUT THE EAR HOOK
If the ear hook needs to be cleaned, carefully
remove it and gently wipe it with a soft cloth.
EXCHANGING THE COLOR SHEET
The sheet inside the cap can be changed to a different color.
1. Turn the cap towards the left and remove it.
2. Turn the cap over, align the cutouts in the color sheet
with the tabs of the cap and press the new color sheet
into place.
3
3. Replace the cap.
Up switch
Ear hook
1. Press and hold the Mode switch for two seconds.
The power will turn on, and the MM-2 will be in Tempo mode.
2. To adjust the tempo, press the Up or Down buttons.
3
3. To adjust the volume, move the volume control.
Adjust the volume for comfortable listening. You will still hear some sound even
when the volume control is in the minimum position.
4. To change the beat, press the Mode switch. The MM-2 will change to Beat
mode.
Press the Up switch or Down switch to change the beat.
To return to Tempo mode, press the Mode switch once again.
5. To turn off the power, press and hold the Mode switch for two seconds.
To protect your hearing, avoid using the metronome at high volumes for
an extended period of time.
* If the display does not appear correct, remove the battery, hold down the Mode
switch for one or two seconds, and then reinstall the battery.
Tempo (39 steps): = 40, 42, 44, 46, 48, 50, 52, 54, 56, 58, 60, 63, 66, 69, 72, 76, 80,
84, 88, 92, 96, 100, 104, 108, 112, 116, 120, 126, 132, 138, 144, 152, 160, 168, 176,
184, 192, 200, 208/minute (BPM)
Beat: 0, 2, 3, 4, 5, 6, 7 beats,
Tempo accuracy: +/-2 %
3
Speaker: Piezo speaker
Power supply: 3V lithium battery CR1216 x 1 piece (included)
Battery life: Approximately 100 hours (continuous use at tempo = 120, beat = 4)
The included battery is for the purpose of verifying operation, and may have a shorter lifespan
than normal.
Dimensions (W x D x H): 76 x 24 x 50 mm / 3.00 x 0.94 x 1.97 inches
Weight: Approximately 19 g / 0.04 lbs. (including battery)
Included items: Owner's manual, Lithium battery (CR1216) x 1, Color sheet x 1,
Ear pad x 1
* Tempo and beat settings are remembered even when the power is turned off. However if you
replace the battery, these settings will return to factory settings (tempo = 120, beat = 4).
* Specifications and appearance are subject to change without notice for improvement of the
product.
OPERATION
Mode switch
Down switch
Volume
SPECIFICATIONS
, ,
2