Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
• Match the corresponding active
(brown), neutral (blue) and ground
wire (yellow-green) and tighten up
screws to make sure power is
properly connected.
• Insert plenum mounting bracket
through
base. Pay attention as the "C" hook
must match the corresponding "C"
area on the base. Finally fasten.
•
Insert 4xM8 bolts, washers, spring
washer
and
mounting frame to the base.
Important: ensure the tightening
torque from 12 to 14 N.m
• Tie the room temperature sensor
onto the rib of mounting bracket.
• Plug the connectors on the plenum
to the base.
Push plenum into outlet duct and
fasten 4xM4 screw on the bottom.
Finally add the filters to the sides of
the plenum.
the
ceiling
to
metal
plate
via
Installation guide
12
Publicité
