H+H BS 22 Mode D'emploi page 12

perature of the content of the bottle or jar as described in „To check the temperature"
before feeding the baby.
6. If the temperature is too low, you can put the bottle or jar back in the baby food
warmer for a few minutes without setting the rotary switch again because the residual
heat is sufficient to heat up the bottle or jar a little more.
Important! After using the baby food warmer, always reset the rotary switch to OFF,
disconnect the unit's plug from the power socket and pour the water out of the baby
food warmer.
6. HEAT RETENTION FUNCTION
The baby food warmer keeps baby food warm for a certain period of time. Simply leave the bottle or
jar in the device after warming up and set the rotary controller to .
Attention: for microbiological and hygienic reasons, baby food should not be kept
warm for longer than one hour.
7. CABLE WINDING
The device has a useful cable winder on the underside. The power cable can be wound up neatly
after using the device, saving space as well.
8. CLEANING AND CARE
Cleaning
Ensure that the device is disconnected from the mains and cooled down before cleaning. Never cle-
an the device when it is hot. Do not use abrasive cleaning agents or pot scrubbers, since this would
affect the surface of the device. After each use, clean the device and the cover with a moist cloth.
Attention! Never submerge the device or the power cable in water or in other liquids!
De-liming
After frequent use (depending on hardness of water) there is a lime scale build-up on the hotplate
on the floor of the device. This lime scale must be removed regularly to ensure that the device
functions properly, else disinfection may be significantly impaired.
Note! In case of slight lime scale build-up we recommend the use of normal vinegar as
described below. Commercially available lime solvents are used for heavier build up –
in any event, the manufacturer's instructions must be heeded.
De-liming with vinegar
1. Before de-liming, ensure that the device is disconnected from the mains and has cooled
down.
2. Mix 100 ml of vinegar with 100 ml of hot water and pour onto the hotplate on the floor
of the device.
3. Allow approx. 30 minutes to take effect, and then pour out. Finally clean the device
with a moist cloth.
Important! Do not use abrasive cleaning agents or pot scrubbers.
12