Security-Center AZ5130 Instructions D'installation page 9

Zone wiring
NC - Sabo
The respective contact closes the
line. No additional resistors are
inserted in the line.
Two-wire detector circuit DEOL
There is a simultaneous
tampering (sabotage) and alarm
monitoring for every detector
circuit (CCT). Different resistors
are required.
Please note that the tamper
connections AT1 - AT8 must
remain free.
Two-wire EOL
With this circuit, each line is
closed by a resistor. All tamper
contacts are connected in series
to the first tamper line.
Tamper lines AT2 - AT8 must not
be connected.
9