Guardian Technologies SD410 Utilisation Et Instructions D'entretien page 3

BATTERY INSTALLATION
1. Remove the dispenser from the refill bottle by twisting it counterclockwise.
2. Remove the battery cover by sliding the release tab and lifting the cover off.
3. Install four AA batteries (not included) in the direction indicated below the cover.
Replace the cover by inserting the tabs on each end then sliding the release tab
down, press to secure the lid then slide the release tab forward to lock in place.
OPERATING INSTRUCTIONS
Use only liquid or gel soap.
IMPORTANT: Do NOT use foaming products.
The unit will not function properly.
FILLING
1. Turn off the dispenser.
2. Remove the dispenser from the refill
bottle by twisting it counterclockwise.
3. Pour soap/sanitizer into the bottle.
4. Return the dispenser to the refill bottle
and turn clockwise to lock.
USAGE
The power button turns the unit on/off and
allows for either a low or high dispensing
volume selection. Wait until the light has
stopped flashing to switch to the next mode.
E-4
USAGE
(Continued)
Power ON
Press and hold the button for 2 seconds to turn the unit ON. The blue indicator light
briefly flashes, indicating the product is on.
Mode 1
Quickly press the button to select low dispensing volume mode (suggested for thinner
solutions such as standard liquid soaps/sanitizers). The blue indicator light briefly flashes,
indicating it is switching modes.
Mode 2
Quickly press the button again to switch to high volume mode (suggested for thicker
solutions such as gel soaps/sanitizers). The blue indicator light briefly flashes, indicating
it is switching modes.
Power OFF
Press and hold the button for 2 seconds to turn the unit OFF. The indicator light changes
to red and briefly flashes.
Note: if the dispenser isn't used for a while, it may need to be primed a few times by
placing your hand under the spout/sensor area to activate it.
Low Battery Indicator
A red LED will flash when the battery is low. When flashing, replace batteries.
Note: the unit cannot be turned on with too low of a battery.
Cleaning
Regularly clean the nozzle if there is a build-up of soap
Periodically clean the sensor with a damp cloth.
TROUBLE SHOOTING GUIDE
PROBLEM SOLUTION
Unit won't power on. Make sure batteries are inserted properly.
Replace with new batteries.
Too much/too little soap Adjust the liquid volume (see filling instructions).
is being dispensed.
No liquid is being Make sure batteries are working properly.
dispensed.
Confirm delivery tube is connected and in the liquid.
Refill soap.
Unit turns off. When the unit is on, holding the power button down for
too long will turn it off. Try lightly touching buttons to
switch modes.
Make sure batteries are working properly.
E-5