Publicité
Les langues disponibles
Les langues disponibles
Items provided in kit SK100-WM Security Kit :
Security Enclosure Bracket (A)
Notes
The security kit instructions are meant for enclosures that are installed on wall mounts.
•
The security kit is to be installed on the back side of the enclosure, and can be installed on the right side or
•
the left side. These instructions illustrate the left-side installation.
Padlock is not included in security kit
•
Installing Security Bracket for enclosure
Figure 1
Figure 2
Figure 3
Security Enclosure
Bracket Screw/Washer
(B)
1.
Enclosure should be installed on wall mount before starting Security Kit
Installation.
2.
Remove cable cover (if already attached) from the back of the enclosure,
and set aside.
3.
Align Enclosure Bracket (A) with bottom left attachment hole for cable
cover and the corresponding hole in the threaded insert on the back panel of
the enclosure (Figure 1).
4.
After aligned, fasten the Enclosure Bracket to the back panel with the
Stainless Steel Screw and Washer (B).
5.
Trim gasket on Cable Cover by using razor knife or scissors) approximately
1" from the bottom as shown (Figure 2).
6. Be sure to trim the correct side because the Cable Cover will overlap the
security Enclosure Bracket (Trim from the right side, for a left-install, and the
left side for a right-install.)
7.
Attach the Cable Cover so that it overlaps the Enclosure Bracket and
secures the Enclosure Bracket in place (Figure 3).
Security Wall
Bracket (C)
Publicité
