Recording - Sony MPK-DVF5 Mode D'emploi

Recording

Now you are ready for underwater recording.
When you dive with the camcorder, dive slowly, paying attention to the surrounding environment.
Be careful not to strike the marine pack against rocks or reef, etc.
POWER switch
AUTO FOCUS
ON/OFF button
REC lamp
(red)
LEAK lamp
(yellow)
1
Set the POWER switch to ON.
The camcorder turns on and a picture appears on the LCD monitor.
2
Press START/STOP button to start recording.
The REC lamp (red) lights up during recording.
To stop recording, press START/STOP button again.
To zoom
Press ZOOM button.
Press T for telephoto (subject appears closer) and W for wide-angle (subject appears further away).
You cannot change the zooming speed of the camcorder.
Recording a still image
You can record a still image on the camcorder by pressing the PHOTO button.
Note that pressing PHOTO button lightly does not allow you to check the recorded image. For more
details, refer to the operating instructions supplied with your camcorder.
Note
If you use the marine pack with a DVD Handycam, you cannot record still images.
To keep a subject in focus
Press AUTO FOCUS ON/OFF button to set it to OFF. You can still keep the subject in focus even if
fish swim between the camcorder and the subject. Press AUTO FOCUS ON/OFF button again to set
the camcorder to auto focus mode.
Note
Do not cover the control emitter or detector with your finger as the remote control signal for
operations is transmitted from the grip to the marine pack.
16
-GB
ZOOM button
PHOTO button
START/STOP
button