KLASS Fan HACKNEY Manuel D'utilisation page 18

2
- Select the right down rod depending
on the height of your ceiling.
- If neither of the down rods fits,
contact your fan distributor.
- Remove the locking pin, the two
screws off the coupler.
- Place the downrod through the
coupler cover and the canopy, and
route the electrical cables through the
downrod.
- Insert the downrod into the coupler,
insert the coupling screws and the pin,
tighten the two screws on the coupler
and close with the cover.
3
- Fixing blade to the motor assembly
with the screws.
- Repeat step for all blades.
4
Hang the fan motor housing on the
mounting bracket, ensure the ball joint
locating the groove aligns with the
notch on the mounting bracket.
coupler
Screws
Notch
Locating groove
16
power cord
canopy
coupling
cover
bolt
locking pin
Motor assembly
Blade