Publicité
Les langues disponibles
Les langues disponibles
to stop the device from dispensing, after which it will switch off automatically.
1
• When the water tank is out of water, the power ON/OFF button
seconds, indicating you need to refill the water tank.
• Caution: Prevent burns. Do not touch the hot boiling water; it is very hot.
• If you are not going to continue using the device, remove the plug from the power socket.
Thermostat
The device features a built-in thermostat that automatically shuts OFF the device in case of overheating or
abnormal operation. If the device becomes too hot (overheating), the thermostat and fuse will activate and stop
the device from working. Let it cool down for approximately 15 minutes and the fuse will reset automatically.
The device can be used again.
In case the device does not operate normally after it has cooled down, it is recommended to reset the
thermostat fuse manually by pushing the reset button key
click. Please use the reset button key
Drip tray
The device is equipped with a removable and variable drip tray.
Depending the cup size used, the drip tray can be placed on 2
different heights. The difference between the 2 heights is 7 cm.
When the drip trap is mounted on the lowest position
available space between the drip tray and spout = 17 cm.
When the drip trap is mounted on the highest position
available space between the drip tray and spout = 10 cm.
When the drip tray is full, hold the device on top, and remove the drip
tray by moving it upwards, releasing it from the drip tray holders.
Empty the drip tray, rinse it with running water, dry it with a dry cloth
and place it back at the desired height, sliding it over the drip tray
holders
or
with a gentle push.
8A
8B
3
for this action.
B
A
B
Drainage stopper
In case the device will not be used for a long period of time, clean it and
remove the wastewater.
Open the drainage stopper
wastewater can flow out . Once all the wastewater has been removed,
place the drainage stopper
tightens well.
Note! In case of any water leakage after filling the water tank, check that the
drainage stopper is properly tightened.
flashes blue and green alternately for ± 30
1
in the small reset buttonhole
B
C
by turning it counterclockwise, so the
C
back by turning it clockwise and make sure it
C
, the
8A
, the
8B
8B
, until you hear a
A
8A
EN 05
Publicité
