Mobilex KAKADU Manuel D'utilisation page 20

Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
24" wheel set 302017 und 302023 (Accessories)
It is possible to easily replace the 2 rear 5" wheels with 24" wheels. All parts, including mounting brackets and
brakes, are included in the accessory kit.
Mounting of 24" wheels
Mounting plates
for 24" wheels
24" quick-release
axle
● Remove the 2 rear 5" wheels by loosening the bolts.
● Place the mounting brackets as shown in the picture above.
● Several holes have been drilled in the frame to allow a single height adjustment. Choose a height and insert
and secure the mounting bolts with the corresponding washers.
● Press the quick release axle located in the middle of the wheels. Insert the axle into the brackets as far as it
will go and release the push button.
● Take hold of the wheels and check that they are properly fastened.
● To remove the wheels, press the push button while pulling the wheel with the other hand.
● After fitting 24" wheels, it may be necessary to adjust the front wheels so that the chair appears horizontal.
Brake assembly with 24" wheels:
The 24" wheel set (302017 or 302023) comes with 2 parking brakes with brackets. The brakes are mounted on the
wheelchair frame and are used to lock the two rear wheels.
Attach the brake to the
frame
● When 24" wheels are fitted it is necessary to fit normal wheelchair brakes.
The brakes consist of mounting brackets, the brake itself and 2 fixing bolts.
●
● Insert the brake adjustment profile into the smallest opening of the brake caliper.
● Place the mounting bracket on the horizontal tube of the chair as shown in the picture.
● Move the brake until the friction pin almost touches the tyre.
● Secure the bolts so the brake is stable.
● To apply the brakes, push the brake lever forward. To release the brake, pull the lever backwards.
Rev. 14.06.22
Fixing screws
for the mounting plate
Rear 5" wheel
Brake released
20 - 40
Brake lever
Friction surface
on the brake
UM-302015-20-MULTI_14062022.odt
Mounting clamp
of the brake with
2 screws for fixing
Adjustment slider for
brakes
Brake locked