Cleaning And Troubleshooting Of Your Appliance; Cleaning Of The Appliance; Troubleshooting - Brandt TI1801 Manuel D'instruction

3. CLEANING AND TROUBLESHOOTING OF YOUR APPLIANCE

A. Cleaning of the appliance
Switch off and unplug the appliance. Let it cool down before cleaning.
1. Concerning the glass-ceramic and the control panel
 Light dirt: clean with a soft wet cloth.
 Oily dirt: clean with a soft wet cloth dipped with little toothpaste or neutral detergent until the
removal of residuals.
Remark: during the cleaning, never clean the surface of the induction cooker with a rigid brush.
2. Concerning the air entry and the air vent
After a long time of use, some dust or other dirt may be accumulated at the air entry or air vent. Use a
flexible brush or a detergent to clean it. The body of the appliance can be cleaned with caution with a dry
cloth.
Remark: never immerse the induction cooker in the water and do not maintain it with a steam
cleaner.
B. Troubleshooting
Here are the recommended inspections of common failures:
Do not disassemble the unit by yourself to avoid any dangers or damage to the induction cooker.
Problems
After the plug in the socket, the indicator
the screen
do not light up.
The button lights up but heating does not
start.
Heating stops suddenly during operation.
E3, E6
Failure
codes
E7, E8
E1, E2, E4, E5, EB
- Make sure that the plug is inserted tightly.
- Make sure that the switch, socket, fuse and
and
power line are in good condition.
- Make sure that the containers are suitable for
induction cooker.
- Sent it to service facility to repair
- Let the appliance cool down
- Let air entry and air vent free
- Set again the timing
- Refer to failure codes
After a moment, temperature inside the cooker
returns to normal. The unit can restore its work
once the « on/off » button is pressed.
After adjusting the voltage, the unit restores its
work.
Send it to service facility to repair.
23
Points to check