Mounting The Suction Cup Bracket; Operation; Powering On - AEG GF 30 Mode D'emploi

GB
27

Mounting the suction cup bracket

Caution! When mounting the camera please be sure not to obstruct your field of
vision, the charging cable will not interfere with driving and the camera is mounted
securely.
Attention! Some automakers' vehicles feature panes with reflective coating as
standard or as special equipment. In this case, mount the GPS sensor in a position
able to receive a GPS signal to ensure smooth operation.
Attention! Risk of damage! Do not over-tighten the threaded connection.
1. release the lever on the suction cup bracket (8).
2. Place the suction cup bracket in a suitable location (e.g. windscreen) and lock
the lever to secure.
3. using the knurled screws on the joints, adjust the camera to the desired position.

oPerAtIoN

Note: Please also see information under "Settings".

Powering on

Holding the PoWer button (4) will switch the camera on. You will hear a sound.
the camera is immediately active and will start recording. the blue LeD will flash.
Note:
If the cockpit camera is permanently connected to the car outlet using the uSB con-
necting cable, the camera will start recording once the car outlet is powered. Please
refer to the owner's manual for your vehicle.