SEVERIN UZ 3861 Mode D'emploi page 7

Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Familiarisation
1. Push switch
2. Drive unit
3. Processing bowl
4. Cutting blade unit
5. Power cord
6. Rating label (on underside of drive
unit)
7. Lid
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the drive unit.
This product complies with all binding CE
labelling directives.
Important safety instructions
●
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
Do not allow the appliance or its power
cord to touch hot surfaces or to come
into contact with any heat sources.
●
After switching off, always wait until the
motor has come to a complete standstill
before removing the drive unit from the
processing bowl. Do not touch any
moving parts.
●
Caution: the blades are extremely sharp.
To prevent injuries, take special care
when handling these parts.
●
Do not operate the appliance when the
All manuals and user guides at all-guides.com
Food chopper
bowl is empty.
●
Always remove the plug from the wall
socket after use, and also
- in case of any malfunction
- when cleaning the appliance.
●
Do not attempt to operate if the drive
unit, the lid or the power cord show any
signs of damage, or if the appliance has
been dropped on a hard surface.
●
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Before using for the first time
Before the appliance is used for the first
time, all parts must be thoroughly cleaned as
described in the section General Care and
Cleaning.
Short-time operation
The appliance is designed to be operated
without interruption for a maximum of 10
seconds, when it should be allowed to cool
down for approximately 1 minute.
Safety switch
This appliance is equipped with two safety
switches. The appliance can only be switched
on if the lid is correctly fitted and the drive
unit properly mounted on top of the
processing bowl.
Operation
- Fit the cutting blade unit into the bowl
before filling the bowl with the food to be
processed. Exercise extreme caution: the
4