Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product No. 043-2736-6
Technical Information
Grind Size Collar
Burr Grinder
Housing
Note: Product may vary slightly from illustration.
6
w03a_0432736_6_CoffeeGrinderManual_ENG.indd 6-7
Hopper Lid
Bean Hopper
Digital Display Screen
Dynamic Control Dial
Sealable Co ee
Grounds Bin
Cleaning Tool
Secret-Until-Lit Display Screen
Dynamic Control Dial
1-800-263-9768
Using Your Coffee Grinder
Precisely grind fresh coffee beans in your PADERNO
Conical Burr Coffee Grinder for a flavourful,
delicious cup of coffee.
Before First Use
Refer to the Cleaning & Maintenance
section of this manual. Clean the
appliance thoroughly before first
use. Remove all packing material
and accessories.
HOW TO USE
1.
Place appliance on a flat surface
and plug in.
NOTE: Digital Display will go into
Sleep mode after 2 minutes of
inactivity. Rotate the Dynamic
Control Dial or click the Dial to wake
the Burr Grinder up.
2.
Remove the Bean Hopper by
rotating counter-clockwise and
lifting off the Burr Grinder Housing.
Secure the Bean Hopper back on
to the Burr Grinder Housing by
aligning it with the Grind Size Collar
and rotating clockwise until it locks.
NOTE: The Burr Coffee Grinder will
not operate if the Bean Hopper is
Figure 1 Images
not correctly locked onto the Burr
Grinder Housing.
3.
Pour up to 340 g (12 oz) of freshly
roasted Coffee Beans into the
Bean Hopper.
4.
Secure the Coffee Grounds Bin in
the Burr Grinder Housing. Ensure the
Grounds Bin Lid is on but the outlet
hole is not covered by the cap.
Figure 4 Image
www.paderno.com
TM
5.
Rotate the Grind Size Collar to
select the desired grind size from
1-30 (see Figure 1). Refer to the
Tips section to see the best grind
sizes for the type of coffee you are
looking to make.
Fig. 1
Figure 1 Images
Figure 1 Images
6.
Rotate the Dynamic Control Dial to
select the number of cups you would
like to brew. Grind sizes 1–5 can be
adjusted to grind
1–6 cups while
grind sizes 6–30
can be adjusted
Fig. 2
to grind 1–12
cups (see Figure 2). Click the Dial to
Figure 2 Image
confirm the selection.
7.
Rotate the Dynamic Control Dial to
Figure 4 Image
Figure 4 Image
micro-adjust the pre-set grinding
time by up to 3 seconds, if desired
(see Figure 3). Click the Dial
to confirm the
selection and
begin grinding.
NOTE: Press and
hold the Dial
Fig. 3
for 2 seconds to return to the cup
Warning Modes
selection setting.
7
2020-10-15 12:32 PM
Publicité
Table des Matières
