AUTO-HAK R25 Instructions De Montage page 4

FITTING INSTRUCTION
7
A
13
10
15
9
11
C
5
B
1
3
21
2
This towbar is designed to assembly in following cars:
FIAT PUNTO II, 3/5 door VAN (188), except Sport, produced since
09.1999 till 2011, catalogue no. R25 and is prepared to tow trailers max
total weight 1200 kg and max vertical load 60 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
B
4
13
8
10
From manufacturer
1. Disassemble the rear bumper.
2. Lower the silencer and unscrew the thermal sheet.
3. Take plastic covers out the bottom part of chassis members.
4. Under the conservation layer in the luggage part (please look for it in
the nearest part of rear car`s side), find elongated holes at the left and
right side. Slide nuts on the jibs (pos. 6 and 7) there.
5. Apply left bracket (pos. 5) to the left chassis member, and right
bracket (pos. 4) to the right one, then fit these elements to slided
earlier nuts (pos. 6 and 7) through holes A, and next fit them to the
rear panel through holes B.
6. Drill holes of supports C (use bit ø12,5mm).
7. Fix the main bar of the towbar (pos. 1) to brackets (pos. 4 and 5) with
6
bolts M12x35mm (pos. 9).
8. Position the ball of towbar (pos. 2) with socket plate (pos. 3) and fix
using bolts M12x75mm (pos. 8) from the towbar accessories.
A
9. Replace the silencer, the thermal sheet and the bumper.
10. Tighten all bolts according to the torque shown in the table.
15
11. Connect electric wires of 7-poles socket according to the instruction
of the car. (Recommend to make at authorized service station).
C
12. Complete paint layer damaged during installation.
11
9
M6 - 11 Nm
M12 - 87 Nm
After install the towbar you should get adequate note in registration book
(at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M8 - 25 Nm M10 - 50 Nm
M14 - 138 Nm M16 - 210 Nm
NOTE