Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
A
8
8
5
This towing hitch is designed to assembly in following cars:
SEAT IBIZA, 3/5 doors, GLX/GTI (6K), produced since 02.1996 till 09.1999,
catalogue no. SC07 and is prepared to tow trailers max total weight 1100 kg and
max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
8
5
1
4
3
2
From manufacturer
A
1. Remove
(reinforcement not used any more).
2. To chassis members put main bar of tow-bar (pos. 1) in that
way so holes (pos. A) agree with existing holes in chassis
members.
3. Reassemble the bumper after cut out its fragment 75x85mm.
8
4. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
M12x75mm (pos. 4) from accessories.
5
5. Tighten all bolts according to the torque shown in the table.
13
6. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station)
7. Complete paint layer damaged during installation.
After installation of a towing hitch you should get adequate note in
registration book (at authorised service station). The car should be
equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towing
hitch must be always kept clear and conserve with a grease.
The instruction of the assembly
the
bumper
and
his
Torque settings for nuts and bolts (8,8):
M 8
25 Nm
M 10 55 Nm
M 12 85 Nm
M 14 135 Nm
NOTE
metal
reinforcement
Publicité
