AUTO-HAK C54A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
A
5
5
4
This towing hitch is designed to assembly in following car:
FORD MONDEO, 5 door (Mk4), produced since 05.2007 till 09.2014,
catalogue no. C54A and is prepared to tow trailers max total weight 2120
kg and max vertical mass 80 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
A
6
5
5
1
3
From manufacturer
1. Disassemble bumper together with its metal reinforcrment
(reinforcement will be not reinstall). Reinstall bolts of
reinforcement.
2. Take of a muffler from last handle and disassemble heatproof
4
plate.
3. Slip in main bar of the towbar (pos. 1) to chassis mamber
that way, so holes of main bar agree with holes prepared in
chassis members . Fix loosely at points A by bolts
M10x40mm (pos. 5).
4. Inside chassis members put nuts on the jib (pos. 4) and fix
using bolts M10x40mm (pos. 5) as shown in the figure. Use
big washers (pos. 6) – see figure.
5. Reassemble heatproof plate and hang up a muffler.
6. Fix body of the automat, the socket plate (pos. 3) and place
tow-ball (pos. 2) according to supplied instruction.
7. Tighten all bolts according to the torque shown in the table.
8. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized
service station).
9. Complete paint layer damaged during installation.
2
After install the towing hitch you should get adequate note in registration
book (at authorised service station). The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towing
hitch must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE