AUTO-HAK J14 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
6
3
This towbar is designed to assembly in following cars:
HYUNDAI ACCENT 3/5 doors (LC, HC), produced since 01.2000 till
11.2005, catalogue no. J14 and is prepared to tow trailers max total weight
1100 kg and max vertical mass 50 kg.
From manufacturer
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right opera-
tion. For this reasons we kindly ask to read carefully this instruction and apply to
hints.
The towbar should be installing in points described by a car producer.
6
1
5
4
2
The instruction of the assembly
1. Apply the main bar of the towbar (pos. 1) to the frame of the
car and through holes (pos. A) fix it using bolts
M12x1,25x35mm – pos. 6 (loosely).
2. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts
M12x75mm (pos. 4) and M12x70mm (pos. 5) from accesso-
ries.
3. Tighten all bolts according to the torque shown in the table.
4. Connect electric wires of 7-poles socket according to the in-
struction of the car. (Recommend to make at authorized ser-
vice station).
5. Complete paint layer damaged during installation.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 12 - 85 Nm
After install the towbar you should get adequate note in registra-
tion book (at authorised service station).The car should be
equipped with:
Indicators
Tow mirrors
Check all bolts and nuts after 1000km of exploitation. The ball
of towbar must be always kept clear and conserve with a grease.
M 10 - 55 Nm
M 14 - 135 Nm
NOTE