AUTO-HAK A03A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
6
7
8
8
Fig. 1 A
This towbar is designed
AUDI 80, 90, 4 door, Quattro (8C, B4), except RS, produced since 09.1991 till
12.1994, AUDI 80 Avant, estale, Quattro (8C, B4), except RS, produced since
09.1991 till 12.1995,catalogue no. A03A and is prepared to tow trailers max total
weight 1700kg and max vertical load 70 kg.
Torque settings for nuts and bolts (8,8):
M6 - 11 Nm M8 - 25 Nm
M12 - 87 Nm M14 - 138 Nm
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
6
8
8
1
5
3
to assembly in following
M10 - 50 Nm
M16 - 210 Nm
NOTE
1. To install the towbar you have to disassemble the bumper and next
- disassemble handles of the bumper
- cut off three brackets (see figure 3)
7
- in bottom edge of bumper, in axis, cut off fragment 50x60mm
2. Enlarge enter of chassis members by cut fragment according to figure 2.
4
3. Through holes of towbar pos. A fix handles (pos. 4 and 5) using bolts
M8x25mm (pos. 7).
A
4. Fix bumper to the main bar of the towbar using original bolts after
disassembling of handles of the bumper
5. Main bar of the towbar together with bumper slip into chassis members in this
way, so holes of towbar agree with original prepared holes and fix from inside
bumper using bolts M10x110mm (pos. 6) as shown in figure 1.
6. Tighten all bolts according to the torque shown in the table.
8
7. Fix body of the automat and place tow-ball according to supplied instruction.
Note! Remember to place socket plate (pos. 3) as shown on the drawing 1.
8. Connect the electric wires according to the instructions of the car.
(Recommended to make at service station).
9. Supplement the paint coating damaged during assembly.
2
Fig. 2
cars:
Fig. 3
The instruction of the assembly
L R