AUTO-HAK A17 Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
11
5
B
4
This towbar is designed to assembly in following cars:
AUDI A8, 4 door, QUATTRO (S8), produced since 06.1994 till 09.2002,
catalogue no. A17 and is prepared to tow trailers max total weight 2350 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
7
A
Bolt existing
in the car
16
1
13
17
6
8
3
From manufacturer
1. Disassemble the bumper.
2. Disassemble original towing eye from the right, rear side of the
car (not used any more).
3. Disassemble rear handle of the muffler fastener.
4. Disassemble handle of bumper fastener (left side), put bolt on the
jib (pos. 5) (place it in original hole as existing bolt (pos. A) on the
4
right side).
5. Put main bar of the towbar (pos. 1) in this way, so towbar holes
agree with holes in chassis and fix as show on the figure (use
washers pos. 16).
6. Fix bracket of muffler fastener (before install remove bolt from it),
this will make possible to fix above mentioned to bolt (pos. B).
7. Reinstall the bumper.
8. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts
M12x70mm (pos. 6) from accessories.
9. Fix the socket plate (pos. 3) as shown on the drawing.
10. Tighten all bolts according to the torque shown in the table.
11. Connect electric wires of 7-poles socket according to the
instruction of the car. (Recommend to make at authorized service
2
station).
12. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration
book (at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be
always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE