AUTO-HAK R33A Instructions De Montage page 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
7
22
5
9
12
17
Fig. 1
11
This towing hitch is designed to assembly in following car:
FIAT STILO ESTATE, produced since 11.2002 till 2008, catalogue
number R33A and is prepared to tow trailers max total weight 1300 kg and
max vertical load 60 kg.
The instruction of the assembly
1. Disassemble the bumper and metal support.
2. Drill the holes ø11 outside the left and right chassis members (see the fig.2).
3. Position the left bracket (pos. 5) to the drilled holes in the left chassis member
and element (pos. 4) to the drilled holes in the right one and fix it together with
fish-plates (pos. 6 and 7) (Attention!!! Fish-plates 6 and 7 put inside the
chassis members).
4. Position the main bar of towing hitch (pos. 1) and fix it using bolts
M12x40mm (pos. 11) and together with jibs (pos. 8 and 9) using bolts
M10x35mm (pos. 12).
5. Cut the metal support according to the fig. 3 and then reassemble it.
6. Cut the bumper according to the fig. 4 and then reassemble it.
7. Tighten all nuts and bolts according to the torque shown in the table.
8. Place tow-ball (pos. 2) according to supplied instruction.
6
8
14
12
17
1
10
13
3
9. Fix the socket plate (pos. 3) as shown on the drawing.
10. Connect to the electric wires according to the instructions of the car.
11. Complete the paint cover of towing hitch (during the mounting paint cover
4
could be destroyed).
11
After install the towing hitch you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
Indicators
2
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch must be always
kept clear and conserve with a grease.
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
175
drill
Fig. 2
Fig.2
original
holes
Fig. 3
Rys 3
CUT OUT
80
80
drill
original
holes
Fig. 4