AUTO-HAK V08 Instructions De Montage page 6

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
5
10
Fig. 1
This towbar is designed to assembly in following car:
NISSAN ALMERA 4 doors, N15, produced since 09.1995 till 03.2000,
catalogue no. V08 and is prepared to tow trailers max total weight 1600 kg
and max vertical load 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
exploit. For this reasons we kindly ask to read carefully this instruction and apply
to hints.
The towbar should be install in points described by a car producer.
7
6
4
1
3
From manufacturer
1. Unscrew the bumper.
2. Get lower a muffler and unscrew thermal shield.
9
3. Unscrew original tow eye (not used any more).
4. Cut out fragment of bumper as shown in the fig. 2.
Fig. 2
From rear part of car body remove bumper handle (on the right side) – see fig. 3.
5.
8
2
6. Put main bar of the towbar (pos. 1) to chassis and fix as shown in the fig. 1, use angle
element – pos. 5 (left side) and elements pos. 4, 6 and 7 (right side).
7. Assemble the bumper.
8. Fix tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12x75mm (pos. 8) from
towbar accessories.
9. Tighten all bolts according to the torque shown in the table.
10. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station).
11. Complete the paint coating damaged during installation.
After install the towbar you should get adequate note in registration book (at authorised
service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km check all screws. The ball of towbar must be always kept clear and conserve
with a grease.
The instruction of the assembly
50
33
Fig. 3
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Remove handle