FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
7
4
5
5
A
This towing hitch is designed to assembly in following cars:
FORD ESCORT IV 3/5 doors, Cabrio, except 4x4, produced since
01.1996 till 10.1998, catalogue no. C10 and is prepared to tow trailers max
total weight 1250 kg and max vertical load 50 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towing hitch depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towing hitch should be install in points described by a car producer.
7
5
A
1
6
3
From manufacturer
1. It is not necessary to reassemble the bumepr.
2. Find original signed places inside the boot on the left and
right side, then drill ø24mm.
4
3. Slide the sleeves L=50mm (pos. 5) and position the element
(pos. 4).
5
4. Position the main bar of towing hitch (pos. 1) and fix it
A
through the holes (pos. A), sleeves (pos. 5) and the elements
(pos. 4) using M10x90mm (pos. 7).
5. Tighten all nuts and bolts according to the torque shown in
the table.
6. Position the ball of towing hitch (pos. 2) together with socket
plate (pos. 3) and fix it with M12x75mm (pos. 6) from the
14
towing hitch accessories.
Connect the electric wires according to the instructions of the
7.
car.
Complete the paint cover of towing hitch (during the
8.
mounting paint cover could be destroyed).
2
After install the towing hitch you should get adequate note in
registration book (at authorised service station).The car should be
equipped with:
Indicators
Tow mirrors
After 1000km check all bolts and nuts. The ball of towing hitch
must be always kept clear and conserve with a grease.
Fitting instructions
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm
M 10 - 55 Nm
M 12 - 85 Nm
M 14 - 135 Nm
NOTE