Publicité
Les langues disponibles
Les langues disponibles
FITTING INSTRUCTION
Clamp mark
in acc. with
Cables joining
ISO
PN
1
L
Left directional lights
2
+
Rear fog lights
3
31
Ground
4
R
Right directional lights
5
58R
Right side parking lights
6
54
Stoplights
7
58L
Left side parking lights
7
14
A
13
C
5
9
4
12
This towbar is designed to assembly in following car:
FIAT MULTIPLA II, VAN, catalogue no. R36 produced since 09.2004 and is
prepared to tow trailers max total weight 1300 kg and max vertical load 70 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and correct
exploitation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
B
8
10
6
1
11
27
2
3
26
From manufacturer
The instruction of the assembly
1.
Remove fitted carpet and anti-noise mat from the boot
2.
Take out a spare wheel. Get lower the muffler, take him out from last handle.
Disassemble a rear bumper.
3.
Inside boot find four original marked points (two per each side). Drill it using bit
ø10,5mm.
N°M
8
N°M1
0
4.
On drilled holes put fish-plates (pos. 7 and 8). Holes pos. A on drilled holes.
5.
Mark rest holes of the fish-plates and drill it:
holes B using bit ø9mm
-
holes C using bit ø10,5mm
-
Holes A and C drill again using bit ø17,5mm only from inside of boot. To this holes
6.
put distance sleeves as shown on figure 2.
7.
On in this way prepared places put elements 7 and 8, by holes A and C put bolts
M10x130mm (pos. 13).
8.
Underneath the car, on protruding bolts put elements 4 and 6 and fix it loosely.
9.
Between element 4 and 6 put main bar of the towbar (pos. 1) and fix it using bolts
M12x35mm (pos. 12).
10. By holes B in elements 7 and 8 put bolts M8x30mm (pos. 14) and fix with plate (pos.
5), use washers pos. 19.
11. Screw tow-ball (pos. 2) and socket plate (pos. 3) using bolts M12 x 75 mm (pos. 11)
from accessories.
12. Tighten all bolts according to the torque shown in the table.
13. Connect electric wires of 7-poles socket according to the instruction of the car.
(Recommend to make at authorized service station)
14. Complete paint layer damaged during installation.
Torque settings for nuts and bolts (8,8):
M 8
25 Nm
M 12 85 Nm
rear axle
N°M
8
N°M1
0
tow ball
M 10 55 Nm
M 14 135 Nm
Publicité
