Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

EN
OPERATOR'S MANUAL
A Division of Snow Joe
Battery Installation + Operation
1. Make sure the unit is turned off and switch is in center position.
2. Locate battery compartment on the back panel of illum-n-broom. Loosen and remove
battery cover using a coin or slotted screwdriver. Your hand works pretty good, too.
NOTE: The battery compartment cover must be properly aligned to maintain a
watertight seal, and for easy removal later. To reinstall and properly realign the cover
threads, first place the broom head on a flat surface. Next, twist the cover two full
turns to the left, then twist right until tight.
3. Insert two AAA batteries as indicated in the battery compartment, ensuring proper
alignment.
4. Close battery compartment door and tighten to ensure watertight seal. Do not over-tighten.
NOTE: Slide on/off switch right to activate lights. Slide switch left to activate safety blinkers.
Attaching the Pole
A. Secure handle to head.
B. Twist pole to loosen.
m
Battery Caution + Disposal Information
1. Batteries vary according to device. Use the correct size and type of battery specified by the manufacturer of
your device.
2. Install only new batteries of the same type in your product (where applicable).
3. Failure to insert batteries in the correct polarity, as indicated in the battery compartment or manual, may shorten
the life of the batteries or cause batteries to leak.
4. Do not mix old and new batteries.
5. Do not mix Alkaline, Standard (Carbon-Zinc) or Rechargeable (Nickel Cadmium, Nickel Metal Hydride,
or Lithium-Ion) batteries.
6. Do not dispose of batteries in fire.
7. Batteries should be recycled or disposed of as per state and local guidelines.
If you have any questions or comments, please call the Snow Joe
department at: 1-866-SNOWJOE (1-866-766-9563)
© 2020 by Snow Joe
All rights reserved. Original instructions.
LED LIGHTED 4-IN-1 ICE SCRAPER +
SNOW BROOM
R
SJBLZD-LED
®
, LLC
®
, LLC
Form No. SJ-SJBLZD-LED-880E-MR1
A.
B.
C. Extend to desired length.
D. Twist to lock.
®
+ Sun Joe
SAVE THESE INSTRUCTIONS
1
C.
D.
®
Customer Service

Publicité

loading

Sommaire des Matières pour SNOWJOE SJBLZD-LED

  • Page 1 A Division of Snow Joe ® , LLC Form No. SJ-SJBLZD-LED-880E-MR1 Battery Installation + Operation 1. Make sure the unit is turned off and switch is in center position. 2. Locate battery compartment on the back panel of illum-n-broom. Loosen and remove battery cover using a coin or slotted screwdriver.
  • Page 2 State to State. PRODUCT REGISTRATION: Snow Joe strongly encourages you to register your Product. You can register online at snowjoe. com/register, or by printing and mailing in a registration card available online from our website, or calling our Customer Service Department at 1-866-SNOWJOE (1-866-766-9563), or by e-mailing us at help@snowjoe.com.
  • Page 3 RASPA-HIELOS Y CEPILLO QUITANIEVE 4-EN-1 CON LUCES LED MANUAL DEL OPERADOR SJBLZD-LED Forma Nº SJ-SJBLZD-LED-880S-MR1 Una división de Snow Joe ® , LLC Instalación + operación de las baterías 1. Asegúrese de que la unidad esté apagada y el interruptor se encuentre en el centro.
  • Page 4 Web, llamando a nuestra central de servicio al cliente al 1-866-SNOWJOE (1-866-766-9563), o enviándonos un e-mail a help@snowjoe.com. Si usted no registra su Producto sus derechos de garantía no disminuirán;...
  • Page 5 BALAI À NEIGE + GRATTOIR À GLACE 4 EN 1 À ÉCLAIRAGE DEL MANUEL D’UTILISATION SJBLZD-LED Formulaire n° SJ-SJBLZD-LED-880F-MR1 Une division de Snow Joe ® , LLC Insertion des piles et utilisation 1. Assurez-vous que la machine est éteinte et que l’interrupteur est sur la position centrale.
  • Page 6 Snow Joe vous recommande vivement d’enregistrer votre Produit. Vous pouvez l’enregistrer en ligne sur le site snowjoe.com/register, ou en imprimant et en envoyant par courrier une carte d’enregistrement offerte en ligne sur notre site Web, ou par téléphone en appelant notre Service à...
  • Page 7 NOTES | NOTAS...
  • Page 8 snowjoe.com...