Amano American SANDERS CE7 Pro Manuel De L'opérateur page 10

EN
FIG. 6.1 SANDING PATTERN
The unit is factory set to sanding pattern 2.
1. To alter the sanding pattern to 1:
a.) Loosen the locknuts on A & B.
b.) Turn stem A counter clockwise and stem B clockwise in
1/4 turn increments until the desired pattern is achieved.
c.) Tighten locknuts on A & B.
2. To alter the sanding pattern to 3:
a.) Loosen the locknuts on A & B.
b.) Turn stem A clockwise and stem B counter clockwise until
the desired pattern is achieved.
c.) Tighten locknuts on A & B.
3. To move the pattern to the outer edge of the sanding disc:
a.) Loosen locknuts on A & B.
b.) Turn stem A & B clockwise in 1/4 turn increments until the
desired pattern is achieved.
c.) Tighten locknuts on A & B.
4. To move the pattern away from the edge on the sanding disc:
a.) Loosen locknuts A & B.
b.) Turn stems A & B counter clockwise until the desired
pattern is achieved.
c.) Tighten locknuts on A & B.
5. To restore the pattern to factory setting, see illustration in parts
list 1 on page 34.
Machine Set-Up
10
A
3
1
2
Figure 6.1
B