Robot ORCA 300 Notice D'utilisation Et D'entretien page 17

Failure
3.0
MAINTENANCE AND ADJUSTMENT OF POOL CLEANERS
3.1 filter cleaning
a. Unplug the device.
Remove the device from the water
b.
If the device is in the pool, pull on the cable carefully until you can grab the handle. Use only the
handle (absolutly not the cable) to pull it out of the water and then put the unit down until the
largest amount of water flows out of the unit.
Remove the filters :
c.
Put the cleaner on the ground, press the buttons ( 4-1), the covers unlock (4-2), open the covers (
4-3), and remove the filters ( 4-4)
3H flashes
1H, 2H et 3H flash
together
Symbol
1H and 3H flash
with warning sound
4-1
4-3
Cleaning begins for a period of 3 hours
The cleaning stops
Signification
Power suppl
overload
press
4-4
16
Proposition
Stop the cleaner and
check if the impeller is not
obstructed by a foreign
object.
4-2