EXALTA TRECENTO12 Manuel D'instruction page 16

should always be off.
Choose and attached the cutting guide according to the hair length
you prefer. The cutting length is shown in the inner side of each
cutting guide.
In order to put the preferred cutting guide, just attached it in the
supports placed in the two sides of blades (as shown in the picture
here-below)
ISTRUCTIONS FOR A CORRECT USE OF THE HAIR CLIPPER
Here below you can find the cutting method description.
It is important to cut always the hair "against the grain", that is to say
against the direction in which the hair grows.
Clipping without cutting guide
Always comb the hair backwards.
Hold the clipper so that the flat side of the comb attachment is parallel to
your head and move the appliance slowly.
Clipping with cutting guide
The appliance is equipped by 2 cutting guides providing a hair length up
to 12 mm.
Before switching the appliance on, always attach the cutting guide
according to the desired cutting length.
IMPORTANT: always move against the direction in which the hair
grows. Place the comb on the neck and move it slowly, cutting small
locks.
CLEANING AND MAINTENANCE
Before starting cleaning the appliance, always switch it off and
unplug it.
Never immerse the appliance in water.
Clean the unit with a damp and soft cloth.
Never use detergents and solvents to clean the appliance.
After having used the appliance remove the cutting guide and using the
cleaning brush to clean the body of the device, in order to remove any hair
from the cutting blade.
16