CDVI V1SR Mode D'emploi page 2

PRODUCT PRESENTATION
Monitored
Surface mount
High Corrosion resistance
Safety Rope
Delivered with armature
No mechanical wear
Ease of installation
Recommended for interior use
Fail safe (Door unlocked when power off)
Holding force: 180 kg
Built-in varistor: Built-in electronic protection
to eliminate back EMF
Dimensions (L x W x D): 166 x 34,5 x 21mm
Armature dimensions (L x W x D): 130 x 32 x 9mm
Power supply: 12/24V dc
Power absorption: 12 V DC = 600 mA
24 V DC = 300 mA
WEEE & RoHS
EC certification
IP42
PACKAGE CONTENTS
Armature
Magnetic lock
plate
1 1
Steel washer Rubber washer M5x35 screw
2 1
ELECTRICAL CONNECTIONS
12V dc default setup
Wires Correspondance
Red + 12 or 24V dc
-
White - 0 V
NC
Yellow Normally closed
Blue C COM
Orange NO Normally open
The N.O./N.C. signal only switches when the door is
closed with the power to it on.
IMPORTANT NOTE
Check the jumper position before connecting the
lock to the input current. A wrong position could
damage the lock. This type of damage is not
covered by the warranty.
All the information contained within this document (photos, drawing, features, specifications and dimensions) could be perceptibly different and can be changed without prior notice.
166
166
130x32x9mm
130
Fixing plate Security rope Roll pin 5x16
1 2
4,8x16 screw
1 2
Voltage selection jumpers
12V dc
Recommended power supplies
ADC335
V1SR
180 Kg Surface Mount Electromagnetic lock
INSTALLATION
166x20x4mm
166x34,5x21mm
Roll pin
Cap nut
Ce document est la propritété exclusive de CDVI, il ne peut être communiqué à des tiers sans son autorisation.
This document is the exclusive property of CDVI and it may not be disclosed to others without permission.
C.A. :
Material : Aluminium
Wood screw
3,5x25
DWG.: A. Broustal
2 8
Cap nut Manual
1 1
24V dc
BS60
G0301FR1036V01
M5 Screw
Fixing plate
Steel washer
Rubber washer
MOUNTING RECOMMENDATIONS
F0526000005-A
V1SR
Electro Magnetic Lock - 180kg
General tolerance: ± 0.2 Surface condition: Ra 3,2
3
) :
Vol. (mm Weight (g) :
Armature plate
- It is vital to fix the electromagnetic lock and
armature plate solidly on their supports.
- Make sure that the magnet and the armature
meet evenly over their entire mating surfaces.
- The armature plate must be able to pivot slightly
about its center mounting screw to compensate
for any door misalignment.
Security rope
(fixing on the magnetic lock and the frame)
Security ropes
The electromagnetic lock undergoes repeated
shocks and the vibration at the points of fixation
on the frame (frequencies of openings / closures,
attempt of opening wears closed and attempts
of vandalism) which can loosen the fixing bolts/
screws.
To prevent the risk of the electromagnetic block
from falling, install both security ropes supplied,
to guarantee the safety of the users (see plan
above).
EN
Fixing plate
Security rope
Plan M2679-ens
Edition 00
SCALE 1:1
Date 02/05/2018
A3H Project : A0238003
31, av du Gal Leclerc
93691 PANTIN CEDEX
F R A N C E
Tel : 33(0)148910102
Fax : 33(0)148912121
www.cdvi.com