Renkforce 1487097 Mode D'emploi page 4

PC or MAC:
• You can also operate the converter board with a PC or MAC.
• In principle, installation and operation with a PC or MAC is the same as with the Raspberry Pi
Please note! The converter board is not designed for installation in a PC or MAC. If
you nevertheless plan to do so, please observe the special safety instructions of this
manual.
Since the screw set is only intended for attachment to a Raspberry Pi
cially sure that the converter does not cause a short circuit in this case (e.g., through
contact with the PC housing).
When using the 5-pin connector (USB_P or U20_P1), also observe the operating instructions
of your computer or main board for the correct allocation.
Disposal
Electronic devices are recyclable material and do not belong in the household waste.
Please dispose of the product, when it is no longer of use, according to the current
statutory requirements.
You thus fulfil the legal requirements and make your contribution to protecting the
environment.
Technical Data
Voltage supply ................................... via micro USB2.0 (USB_M or U20_M1) or 5-pin con-
Operating voltage .............................. 5 V/DC
Supported operating systems ............ Windows
Connectors ........................................ M.2 NGFF 2280-D5-B port (B key); micro USB2.0
Supported standards ......................... USB 2.0; SATA
Supported devices ............................. M.2 NGFF SATA SSD; type: 2280, 2260, 2242, 2230;
Dimensions (L x W x H) ..................... 89 x 57 x 12 mm
Weight ............................................... approx. 20 g (only the board)
Operating conditions .......................... 5 °C to +50 °C; 20% to 80% rF, non-condensing
Storage conditions ............................. -25 °C to +70 °C / 15% to 90% rF non-condensing
nector (USB_P or U20_P1); alternatively via micro USB
connector (PWR_U or DC5V_IN)
XP SP1 or higher (only 32 bit); Windows
®
Vista , Windows 7, Windows 8, Windows
TM ® ®
Windows 10 (32 and 64 bit); MacOS; Linux
®
connector; 5-pin USB connector; micro USB connector
for separate voltage supply
double sided module, max. height 1.5 mm
.
®
, make espe-
®
8.1,
®
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2016 by Conrad Electronic SE. 1487097_V1_0916_02_VTP_m_en