ROBENS ZY-CL502R Mode D'emploi page 2

LIGHT MODES
Press the button for warm light (700 Lm)
Press the button twice for cool light (300 Lm)
Press the button three times for warm and cool together (1000 Lm)
Press the button four times for flashing mode
In the first three modes, press and hold the button to dim the light
USE OF THE LAMP
Lamp is charged using 5V DC USB power outlet. Micro USB input (6.) is located under protective lid
Charging cable is included with the lamp
Lamp have built in overcharge protection circuit
When charging the power indicator lights red. When fully charged it lights green
When power is low the indicator will light red
Please fully charge the lamp before use
Lamp can also be used as power bank to charge phones etc. USB output (5.) is located under protective lid
Lamp can be used hanging from the hanger, standing, or hanging from the hook
To remove the lampshade, rotate it counterclockwise from the body of the lamp
Lamp can be cleaned with water and a damp rag
Lamp is water resistant to IP44
Do not use corrosive liquids to clean the lamp
Do not stare into the light source
Do not modify the product
LIGHT SOURCE: 12W LED
This product contains a light source of energy efficiency class G.
Light source and control gear is not replaceable.
This would introduce weak points in the construction, that could reduce the lifetime of the product.
INSTRUCTION FOR REMOVAL OF LIGHT SOURCE AND CONTROL GEAR BY MARKET SURVEILLANCE AUTHORITIES
1) Remove lamp shade by hand, rotating it counterclockwise
2) Remove clear lens covering light source PCB, by using a flathead screwdriver to pry back 3 pcs tabs holding it in place
3) Unscrew screws holding light source PCB in place
4) Cut needed wires to remove the required components for testing
2