HAMPTON BAY NTSW30030LBL-MS Guide D'utilisation Et D'entretien page 6

Installation (continued)
3
Mounting the light fixture
Align the mounting holes in the backplate (B)
□
with the two studs (CC).
Insert the two studs (CC) through the backplate
□
(B), and secure the fixture with the two acorn
nuts (DD).
Restore the power at the fuse or circuit
□
breaker box.
CC
DD
B
C
4
Testing the light fixture
The sensitivity switch adjusts the amount of distance
that is required to activate the unit. To set to a desired
level of sensitivity:
Turn on the circuit breaker and the light
□
switch. The sensor has 1-2 minutes warm up
period before it will detect motion. When first
turned on, wait 1-1.5 minutes.
Set the Time switch to the "TEST" position
□
and the Sensitivity switch to the "M" position.
The lights turn off in about 5 seconds. Keep
in mind a better sensitivity is achieved by
walking across the coverage area, not walking
towards or away from the motion sensor.
Set the sensitivity to the "H" position for a
□
higher level of sensitivity and "L" for a lesser
level of sensitivity. The reach is approximately
a 30 ft. radius from the motion sensor if set to
the "H" position.
D to D
2" 6"
Test
Time Switch
6
L M H
PIR Motion
Sensitivity
Switch