Zigo Leader Manuel De Montage Et D'utilisation page 19

3.2 Setting up the Cycle
Lower Kickstand to keep Cycle steady during setup.
1. Install Cycle Front Wheel Skewer.
2. Install Cycle Front Wheel (see Bicycle Manual).
3. Install handlebar.
4. Install LeaderLink Knob.
3.2.1 Install Front Wheel Skewer
The front wheel retention skewer is in the Parts Box. It looks like this:
Tension Nut
1. Unscrew the tension nut from the end of the wheel retention skewer.
2. Insert the skewer into the hollow axle with the narrow end of the conical
springs facing the hub, one spring on each side of the hub
3. Re-install the tension nut.
NOTE
5. Hook up Brake Straddle Wire.
6. Install Pedals.
7. Adjust to fit (see Bicycle Manual).
Conical Spring
Cam Lever
Skewer
19