Phase 3: Toddler + Baby; Carrycot + Seat; Phase 4: Two Toddlers; Two Seats - Mima kobi Mode D'emploi Et Garantie

26 + 27
28
29 + 30

PHASE 3: TODDLER + BABY

• To use kobi for a baby and a toddler, it is required to
purchase the second seat. This second seat does not
have a carrycot inside.

CARRYCOT + SEAT

• Set up the carrycot as described on page 7.
26. Attach carrycot
Make sure the rear seat fixings on the chassis are in
position 1. Position the carrycot so that the angle
adjustment lever is facing backwards.
Rotate the brackets into position II (see also
Click the carrycot onto the lower part of the chassis.
27. Attach seat
Make sure the front seat fixings on the chassis are in the
high position. Position the seat so that it is facing forward.
Click the seat onto the upper part of the chassis.

PHASE 4: TWO TODDLERS

• To use kobi for two toddlers it is required to purchase
the second toddler seat. This second seat does not
have a carrycot inside.
• The second seat comes with XL mudguards. For the
safety of your child please make sure to use these XL
mudguards.
• WARNING
: When using kobi for two toddlers,
always place the heavier child in the front seat.
Never place a child in the rear seat without a child in
the front seat.

TWO SEATS

28. Attach XL mudguards
Slide off the small mudguards (see
them with the XL mudguards.
29. Attach rear seat
Make sure the rear seat fixings on the chassis are in
position 2. Rotate the brackets into position I (see
Click the seat onto the lower part of the chassis.
30. Attach front seat
Click the seat onto the upper part of the chassis.
ENG
fig. 14).
fig. 2) and replace
fig. 14).
9