Introduction; Main Characteristics; Technical Specifications - O&O DEC-SC Manuel D'installation Et D'utilisation

The DEC-SC control unit has been designed to control the automations SMART-800 and MEGA 2000 for sliding doors.
The considerable number of logic units available permits satisfying even special operating conditions on systems.
- Microprocessor logic
- LEDs displaying input status
- Extractable terminal boards on low voltage inputs
- Electric braking with limit switches for gates with special number of cycles and inertia
- Output for gate open indicator light
- Integrated radio receiver 433Mhz
LED
J1: Terminal board
J2: Power terminal block
J3: Low voltage input/output terminal board
J4: Terminal Block Safety edge and Antenna
SW1: "START" control button
SW2: "AP.PED" control button
SW3: Dip Switch
P1: Torque trimmer
P2: Pause time trimmer
F1: Line fuse 6.3A
F2: Low tension fuse 100mA
DEC-SC
Instructions for installation and use

1. INTRODUCTION

2. MAIN CHARACTERISTICS

3. TECHNICAL SPECIFICATIONS

- Power supply:
- Motor output:
- Traffic light:
- SCA output:
- Accessory output 24Vac:
230Vac ±10% 50 Hz.
230Vac; 1,5A max
230Vac; 40W max
24Vac 3W max
3W max
- 9 -
EN