Working With The Letter Opener; Start/Stop - Hefter Systemform OL 420 Manuel D'utilisation

Working with the letter opener

Rear guiding
plate
Place your mail onto the guiding place so that all envelopes are positioned
against the rear guidance.
Make sure that the envelopes are on the transport belts.
Adjust the cutting width by turning the adjusting wheel (from 0,5 up to 4 mm)
Now your letter opener is ready for use!

Start/Stop

First check if the machine is connected.
The power supply must be plugged to the inlet of the letter opener, the plug of the
power cord in the wall socket.
ON n
ON/OFF
switch
Switch on the letter opener ("I").
Now the machine runs and your incoming mail will be fed, opened and stacked.
Make sure that during operation with the letter opener that your fingers, jewellery and
long hair doesn't touch the transport belts.
Switch the machine off when you don't work with it.
Adjustment of
cutting width
Electrical connection
6
Envelope
receiving tray
/ socket